//=time() ?>
Aside from the Kickstarter stuff, this is an enamel pin I’d -like- to get made before those! It would be about 2x1.7 inches, with two rubber clutches on the back, and be 12$! I need to know a rough idea of the interest if any, so poll below!
I was already planning to make this guy: an enamel pin so I’ll try to do that before to get the experience beforehand 😎 (I also might end up going for acrylic pins instead anyways!)
✨ Sketch to Final ✨ for these Mermaid Melody sticker set designs :]
So what are our thots on this as an enamel pin (at SOME point) in the future 😳
Friendly reminder that today and tomorrow are the last two days that this sticker will be a freebie in orders from my shop!! :^)