Lewis RKさんのイラストまとめ

The detail level is optimized for FDM printers and will look very nice if you printed it out with resin printer. Total height is 15 cm. If I convert this model to a tabletop gaming scale it will be about 5 cm. tall which will make the details just right
#3dprint #ACTIONFIGURES

I have to scale up the hand so it look right on bigger mech but that would mean that all the V.7 weapons will not fit. If I make a smaller hole it will look strange. Time to get creative. >:D

#3dprinting #ACTIONFIGURES

At 150 mm. she is a bit taller than most version 7 frames but only by 20 mm. I would rather she is smaller but a 1:24 pilot figure has to fit inside and I can't make it smaller than this.

Arm and shoulder articulation looking good. the bulky chest is not as problematic as I thought it would be. I was expecting a lot less motion range but this is fine.
#3dprint #actionfigures

I shouldn't be too hasty to add the details on the leg but it was just so tempting.
#3dprint #actionfigure

This project's leg articulation is going to be both complicated and interesting. I hope I don't overload the joints by the time I am done with the limbs

#3dprint #ACTIONFIGURES

Tonight's haul. The chest was tricky to draw but I finally found a way.
#3Dprinting #ACTIONFIGURES

If I didn't care that an action figure has to fit inside, the body part would have been done already but noooooo, gotta do it the hard way didn't I.
The design will have to be changed to allow all of these mechanisms to work. Oh well, form follows function right?

#3dprinted

@AndiDev_ It keep reminding me of this

Great job on the setup. Very convinving

Is Pop Team Epic still a thing?