Jeff Lagant /Propmaker/さんのイラストまとめ

Making good progress on the slicing of the N7 Crusader
I'll be using PVC tubing to strenghten it and help with alignement during the assembly.

#MassEffect #3DPrinting #3Dmodeling #Replica

Power is back online

@3dprintnbots Probably haha
I also did some 3d modeling

N7 Valkyrie 3D model in the making
I started it 1.5years ago
Let's finish it.

#3DPrinting #3Dmodeling #MassEffect #Replica

Alright, Scorpion 3d model is done and ready to be printed!
With room for cyan LEDs and an expected autonomy of ~3hours
It could have been more but I didn't had enough room for a 2200mAh powerbank

#3dprinting #MassEffect #Replica #DIY

Checking if that particular part of the M97 Viper from #MassEffect would fit the buildplate with the current scaling.
Crisis avoided.

#3Dmodeling #3Dprinting #Replica

WIP
Makin room for LEDs on the N7 Eagle
The black part on the back will house the CR2032

#MassEffect #3dprinting #3Dmodeling #replica

ALRIGHT SO IF THE FREEZING COLD KEEPS BEING A FUCKIN DICK I GUESS I'LL WORK ON ADDING LEDS TO THE N7 EAGLE SINCE I CAN'T WORK IN THE WORKSHOP BY -5°C

(yes, I'm slightly pissed. How did you guess?)

Same problem as the M3 Predator:
I have no freakin idea where to put the on/off switch for the back LED.
The CR2032 coin cell will go in the removable mag. I'll leave just enough wire lenght so that it's acessible without dangling on the floor when you remove the mag.