Daniel Lilygreen ł Propmaker and Engineerさんのイラストまとめ

Working on the stiffening of the outer body parts as well as making a good stiff assembly for everything to mount to. #3dmodeling #3dmodel #fifthelement

It doesn't look like much but this is the start to the Zorg ZF-1 from #FifthElement. This project was voted on by my supporters on patreons from a number of projects and its one I've wanted to do for some time. #movieprops #3DModel

Starting the #drawing for Mals Pistol which wont take me long and then I'll start on the Iron Mans Arc reactor. Both of those props will be on my Patreon soon. #propmaking

One page mostly done. Theres still tweaks to make and the borders to sort out but once that's done I've pretty much got the generic hieroglyphs done. The other pages are just rearranging of the same 10-15 hieroglyphs in different patterns. #themummy #3dmodel #hardsurface

Hieroglyphs, so many hieroglyphs. The ones on the front are the worst to detail as theres not many good references but there's loads for the internal pages. Once I have this lot done I can start on the pages. #themummy #3dmodel

With the finger and thumb models done with space for wires not just trying to properly integrate them into the wrist body with modelled working envelopes to help positions. Its going to take aa lot of fiddling to get right and be useable. #solidworks #3dmodeling #fallout

A quick snap shot of the #fallout T60 power armour progress. Only the forearms and hands to do and then I'll probably just go over all of the parts and see if I can make any improvements. The model to #3dprint a 1:1 wearable version is on my patreon here https://t.co/CQl1S5hC2e

After sitting down for several hours yesturday I finished the backpack of the #fallout T60 power armour. It took way longer than I thought but its now broken down for #3dprinting and is now on my Patreon. #3dmodel #solidworks

A quick render on my current T60 progress. I've managed to finally do the curved piece that wraps around the cylinders which was a bit of a pain. I've started on the inside reinforcement to try and keep the thickness of the individual pieces down and still keep everything stiff.

Some progress on the #fallout T60 power armor and have made some of the smaller details as well as creating a few of the large surfaces. #3dmodeling #3dmodel #solidworks